Viewing And Editing Classifier Configuration - ZyXEL Communications MGS-3712/MES-3728 User Manual

Chapter 20 Classifier
Table 45 Advanced Application > Classifier (continued)
LABEL
IP
Address/
Address
Prefix
Socket
Number
Destination
IP
Address/
Address
Prefix
Socket
Number
Add
Cancel
Clear
20.3 Viewing and Editing Classifier
Configuration
To view a summary of the classifier configuration, scroll down to the summary
table at the bottom of the Classifier screen. To change the settings of a rule, click
a number in the Index field.
180
DESCRIPTION
Enter a source IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
A subnet mask can be represented in a 32-bit notation. For example, the
subnet mask "255.255.255.0" can be represented as
"11111111.11111111.11111111.00000000", and counting up the number of
ones in this case results in 24.
Note: You must select either UDP or TCP in the IP Protocol field before
you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select
the second option and enter a TCP/UDP protocol port number. Refer to
49 on page 182 for more information.
Enter a destination IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
Note: You must select either UDP or TCP in the IP Protocol field before
you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select
the second option and enter a TCP/UDP protocol port number. Refer to
49 on page 182 for more information.
Click Add to insert the entry in the summary table below and save your
changes to the Switch's run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the fields back to your previous configuration.
Click Clear to set the above fields back to the factory defaults.
Table
Table
MES-3728 User's Guide