Dhcp Snooping Port Configure - ZyXEL Communications MGS-3712/MES-3728 User Manual

Table 77 DHCP Snooping Configure (continued)
LABEL
Apply
Cancel

26.5.1 DHCP Snooping Port Configure

Use this screen to specify whether ports are trusted or untrusted ports for DHCP
snooping.
Note: If DHCP snooping is enabled but there are no trusted ports, DHCP requests
cannot reach the DHCP server.
You can also specify the maximum number for DHCP packets that each port
(trusted or untrusted) can receive each second. To open this screen, click
Advanced Application > IP Source Guard > DHCP Snooping > Configure >
Port.
Figure 126 DHCP Snooping Port Configure
MES-3728 User's Guide
DESCRIPTION
Click Apply to save your changes to the Switch's run-time
memory. The Switch loses these changes if it is turned off or loses
power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done
configuring.
Click this to reset the values in this screen to their last-saved
values.
Chapter 26 IP Source Guard
249