Fan Sink (Thermal Module) - HP TouchSmart 9300 Elite Maintenance & Service Manual

Fan Sink (Thermal Module)

Description
Fan sink (thermal module) for use in computers with discrete graphics
Fan sink (thermal module) for use in computers with UMA graphics
The fan sink is secured with four screws. You do not have to remove the chassis fan to remove the it.
Figure 7-60
To remove the fan sink:
1. Prepare the computer for disassembly (see
2. Remove the stand (see
3. Remove the right and left rear panels (see
4. Remove the left cap (see
5. Remove the right cap (see
6. Remove the rear logo cover (see
7. Remove the rear main frame (see
8. Remove the system board shield (see
9. In the order indicated by the numbers stamped into the heat sink, remove the four screws (1)
that secure the fan sink to the system board.
10. Disconnect the fan cable from the system board (2).
84 Chapter 7 Removal and Replacement Procedures
Fan location
Stand on page
Left cap on page
Right cap on page
Preparing to disassemble the computer on page
34).
Rear panels on page
60).
66).
Rear logo cover on page
Main rear frame on page
System board shield on page
Spare part number
658987-001
658988-001
46).
71).
74).
76).
33).