Hitachi SelecSet 400A User Manual page 53

B CAP
RIDGED S TO
1-42
C
ONFERENCE
6
If your system administrator has set up your phone
system with the multiparty conference capability, you
can place a conference on hold after connecting the
two parties on CAP 1 and CAP 2. You can then take
another call by pressing the <HOLD> key. Both the
CAP key with the conference and the <CONF> key
flash slowly. At least one of these conferenced
members should be an inernal party to prevent
trunk-to-trunk lockup.
Otherwise, remove yourself from the conference if an
incoming internal caller is connected with an outisde
caller.
Note: If three CAPs are busy, you cannot use CAP4 to
initiate a conference or join or bridge two parties.
7
To disconnect the last party from the conference (the
caller on CAP1), press the <DISC> key.
S S 400A U
ELEC ET
HCXTD830, Rev. A01, July 2001
G
SER UIDE