Transferring - Hitachi SelecSet 400A User Manual

T
RANSFERRING

Transferring

Procedure
1-36
Use the following call transfer operation to transfer
(extend) a caller to another number. This procedure can be
used even if both the caller and the desired number are
outside the facility. To transfer a call:
1
After making or answering a call, dial the number to
which you are transferring a call. Remember to dial
the trunk access code (usually 9) if dialing an outside
number.
The caller is automatically placed in consultation
hold. (Consultation hold temporarily removes a party
from the connection so transfer or conference
operations can be performed.) An idle CAP is
automatically selected.
2
To cancel the transfer and return to the caller, press
<CNCL>.
3
To transfer before the called party answers, press
<JOIN>.
4
To announce the call, wait until the user answers and
make your announcement, and then complete the
transfer by pressing <JOIN>.
5
To swap between the two sides of the call, when the
called party answers, press <SWAP>. The active call
and call on consultation hold are switched.
To return to the originally active call, press <SWAP>
again. You can alternate between the two calls as
often as you like. To disconnect the person to whom
you are speaking and reconnect the person on
consultation hold, press <CNCL>.
To exit and connect the two calls, press <JOIN>.
S S 400A U
ELEC ET
HCXTD830, Rev. A01, July 2001
G
SER UIDE