Receiving An E911 Alarm - Hitachi SelecSet 400A User Manual

R E911 A
ECEIVING AN

Receiving an E911 Alarm

About the
E911 alarm
Procedure
2-42
LARM
When someone on the property makes a 911 call, the E911
alarm lamp flashes to alert you to the emergency.
Depending on system setup, this visual alarm may be
accompanied by distinctive ringing, which is -disabled
when you acknowledge the E911 alarm.
To determine who placed a 911 call:
1
Press the <E911> key.
The display shows the number of the station that
made the call. If more than one 911 call was made, the
E911 lamp continues to flash.
2
Press the <E911> key until all 911 calls have been
displayed. When all 911 calls have been displayed,
the E911 lamp stops flashing.
Note: Once a 911 call has been displayed by pressing
the E911 key, information about the station that
placed the call is erased from the E911 alarm
queue.
3
Press <START> or lift the handset to clear the display.
S S 400A U
ELEC ET
HCXTD830, Rev. A01, July 2001
G
SER UIDE