Hitachi SelecSet 400A User Manual page 117

C T
HECKING A RUNK
Procedure,
continued
About the
<LTA/VER>
key
2-54
7
Dial an outside number to check the trunk. You do not
dial the trunk access code (usually 9) before the
outside number. Because you're already connected to
a trunk, you don't need a trunk access code.
8
If the trunk is operational, you hear ringing or busy
tone after the outside number is dialed. If the trunk is
not operational, call your telephone system
maintenance company.
9
Press <START> to disconnect.
Note: The <LTA/VER> key is also used for the long
trunk alarm, which causes the <LTA/VER> key to
flash when a trunk is connected for an unusually
long time. (See
on page 2-41 and
on page 2-42 for more information.) When the
<LTA/VER> key flashes, you can still use it to
check a trunk that isn't causing the alarm.
S S
ELEC ET
"Receiving a Long Trunk Alarm"
"Receiving an E911 Alarm"
HCXTD830, Rev. A01, July 2001
400A U G
SER UIDE