C
2: A
HAPTER
DDITIONAL
Code Calls
About code
calls
Procedure
Receiving a
code call
HCXTD830, Rev. A01, July 2001
O
PERATIONS
A code call indicates an emergency. When you make a
code call, it causes special ringing (four quick rings) at a
station dedicated to receive code calls.
The person receiving the call uses the paging system to
announce the emergency or give appropriate instructions
(there may be several code calling stations throughout
your facility). Keep a list of the code calling access codes
for each dedicated station near your console.
To place a code call:
1
Press <START>.
2
Dial the desired code calling access code. The code
call is sent to the dedicated station.
Note: Code calling access codes can be programmed as
autodial numbers. See
SelecSet 400A"
If you are designated as a code calling station, code calls
ring with a special ringing pattern (four quick rings) at
your <CODE> key and/or <ANS> key. If you receive a
code call, use zone paging to announce the emergency or
give instructions. Keep a list of zone numbers nearby.
"Programming your
on page A-1 for instructions.
C
C
ODE
ALLS
2-55