Resource Protection; Selecting Resource Protection Mode - Kyocera FS-6900 User Manual

2.16.

Resource Protection

When you switch from the PCL 6 emulation to another, all downloaded fonts and macros
are lost. Resource protection preserves these PCL resources in memory so that they are
intact when you change the emulation back to PCL 6.
By using the printer'sý!5HVRXUFHýSURWï, you can select from two resource protection
modes as follows:
!5HVRXUFHý SURWï
ý ý 3HUPDQHQW
In this mode, the printer stores fonts, macros, symbol sets, etc. in memory that were down-
loaded as permanent PCL resources. All temporary resources are lost when the emulation
mode is changed from PCL 6 to another or vice versa.
!5HVRXUFHý SURWï
ý ý 3HUPý îý 7HPS
In this mode, the printer stores both permanent and temporary resources when the emula-
tion mode is changed from PCL 6 to another or vice versa.

Selecting Resource Protection Mode

1.
Pressing the MODE key will put the printer in Mode Select mode.
2.
Press + or – to selectý2WKHUVý!.
3.
Press the key.
4.
Press the + or – key to displayý!5HVRXUFHýSURW. and then press the ENTER key. Aý
" will flash and the current setting can be changed.
5.
Press the + or – key and select the desired setting.
6.
Press the ENTER key.
If you want to change the setting, press the CANCEL key before pressing the ENTER key.
7.
Press the EXIT key. The Resource Protection mode setting is now changed.
2.16. Resource Protection
2-43