Operating A Memory Card; Reading Fonts From A Memory Card - Kyocera FS-6900 User Manual

Operating a Memory Card

The following operations on a memory card inserted into the printer's memory card slot is
possible.
Reading Fonts
Reading Macros
Reading Data
Writing Data
Deleting Data
Formatting a Memory Card
Printing a List of Data Names (Partitions)
Note that only reading fonts and printing a list of partitions are possible when a font card is
inserted. The following sections explain each of these operations.
Each operation is described below.

Reading Fonts from a Memory Card

Fonts can be read into the printer's internal memory from optional font cards. The font read
can then be selected from the printer's control panel. Font cards are automatically read into
the printer when the printer's power is turned on. The operation described here is per-
formed while the message display reads 5HDG\.
1.
Check that the font card is inserted into the memory card slot. Bring up the menuý
!5HDGýIRQWV on the message display. This display only appears if a font card is
inserted.
2.
Press the ENTER key.ý" will appear.
Press the CANCEL key to stop reading fonts.
3.
Pressing the ENTER key again will causeý3URFHVVLQJ to appear in the lower part of
the message display and font data to be read from the font card.
4.
After fonts have been read, the message display will return toý!5HDGýIRQWV.
5.
Pressing the EXIT key will cause the message display to return toý5HDG\.
2.9. Memory Card
2-27