Resource Protection; Adjusting The Print Density - Kyocera FS-1700 User Manual

2.7. Resource Protection

When you switch from the HP LaserJet emulation to another, all downloaded fonts and macros
are lost. Resource protection preserves these PCL resources in memory so that they are intact when
you change the emulation back to HP LaserJet 5M.
By using the printer's MODE SELECT, you can select from two resource protection modes as fol-
lows:

 
 
In this mode, the printer stores fonts, macros, symbol sets, etc. in memory that were downloaded
as permanent PCL resources. All temporary resources are lost when the emulation mode is
changed from HP LaserJet 5M to another or vice versa.

 
  
In this mode, the printer stores both permanent and temporary resources when the emulation
mode is changed from HP LaserJet 5M to another or vice versa.
Resource protection requires extra memory to store the downloaded fonts and
macros. The total size of the printer memory recommended for using the resource
protection option is affected by several factors. See section 1.7. Memory Expan-
sion Installation.

2.8. Adjusting the Print Density

If necessary, the print density can be adjusted from the MODE SELECT MENU. Density can be
adjusted in five steps from  (light) to  (dark). The factory setting is , and there is normally
no need to alter this setting.
When using the KIR function, please use the " " setting.
2.7. Resource Protection
2-17