Maintenance Messages - Kyocera FS-6900 User Manual

Maintenance Messages

Table 5.2 Maintenance Messages
Message
7RS FRYHU
2SHQ
6LGH FRYHU
2SHQ
3DSHU IHHG XQLWý
2SHQ
)DFHðGRZQ WUD\ý
SDSHU IXOO
$GGý SDSHU
(paper source)
(paper size)/(paper type)
*(paper size) and (paper type)
are displayed flashing
alternately.
&DVVHWWH
QRWý ORDGHG
&DVVHWWH
VL]Hý HUURU
6HWý SDSHU
3UHVVý &217,18(
3DSHU MDP
:DUQLQJ
/RZ PHPRU\
2SWLRQý LQWHUIDFH
(UURU
7RQHU ORZ 7.ðëíý
&OHDQ SULQWHU
5HSODFH 7RQHUý
&OHDQ SULQWHU
&OHDQ SULQWHUý
3UHVV &217,18(
Open the top cover, then close tightly.
Open the side cover, then close tightly.
Open the paper feed unit, then close tightly.
The face-down tray has become full (approx. 350 pages). You must
remove all printed pages from the face-down tray.
The paper has run out. Supply paper according to the paper source
displayed (paper cassette, MP tray, or optional paper feeder).
The cassette is not closed securely, close it tightly.
The size set for the paper cassette is incorrect. Be sure to correctly
set the paper guides and paper stopper inside the cassette to match
the paper size being used. See Section 1.4.
Add a sheet of paper to the MP tray, and press the CONTINUE key.
Open the top cover or the paper feed unit and correct the paper jam
(or paper mis-feeding in the cassette). See Section 5.6.
The printer's internal memory is running low due to the number of
fonts and macros downloaded. Print a status page to see how much
user memory is left, and try deleting unnecessary fonts and macros.
See the PRESCRIBE 2e DELF and DELM commands explanation in
the programming manual (CD-ROM).
A failure has occurred with the option interface.
Check the option interface installed on the printer.
Replace the toner container using a new toner kit. See Section 4.1.
Replace the toner container using a new toner kit. The printer does
not operate when this message is displayed. See Section 4.1.
Please clean the inside of the printer. See Section 4.2.
This message will be displayed when replacing the toner container
after the messageý5HSODFHý7RQHUý&OHDQýSULQWHU has
been displayed. After cleaning the inside of the printer, press the
CONTINUE key and the printer will be ready for printing.
5.5. Indicators and Messages
Corrective Action
5-9