Appendix C Host Computer Interface; Parallel Interface; Parallel Interface Communication Modes - Kyocera FS-6900 User Manual

C.1. Parallel Interface
Appendix C
Host Computer Interface
This appendix describes the signals used in the laser printer's parallel, RS-232C/RS-
422A interfaces. It also lists pin assignments, signal functions, timings, connector spec-
ifications, and voltage levels. The RS-232C/RS-422A protocols are also covered.
Finally, it explains the use of the printer in a multi-computer environment.
C.1.

Parallel Interface

Parallel interface communication modes

The printer features fast data transmission on the parallel interface. The parallel interface
mode can be activated from the printer's control panel (see Chapter 2, Operating the Laser
Printer) as follows:
Use a parallel printer cable that complies with the IEEE1284 standard.
Auto [default]
The printer automatically changes its communication mode to the one the host computer is
currently using. Ordinarily, you should leave this setting unchanged.
Nibble (high)
High speed data communication is used in compliance with the IEEE 1284 standard.
Normal
The printer uses the communication method discribed by to the normal definitions of the
Centronics interface.
High-speed
This mode enables faster data transmission between the printer and the host computer.
(Select this mode if printing problems occur when the printer is connected to a workstation.)
C-1