Kyocera FS-6900 User Manual page 112

4.2. Cleaning
Cleaning the Grid
Clean the grid at the time of toner kit replacement.
1.
Take the grid cleaner from protective bag in
the new toner kit, and remove the cap.
The grid cleaner pad is impregnated with
water. Perform the following cleaning pro-
cedure before the pad dries.
2.
Attach the grid cleaner to the printer with
the pad uppermost, as shown in the figure.
3.
After attaching the grid cleaner, repeat the
action of slowly pulling out and then push-
ing back in the main charger unit at least 5
times. It is easier to pull out the main
charger for the first time if it is raised
slightly, as shown in the figure.
The grid part underneath the main charger
is cleaned by this procedure.
4.
When the grid is clean, remove the grid
cleaner from the printer and dispose of it.
The grid cleaner is not re-usable.
5.
After cleaning the charger wire and grid,
push the cleaning knob all the way in and
close the side cover.
4-8
Protective Bag
Main Charger Unit
Cap
Pad
Grid Cleaner
Grid Cleaner