Kyocera FS-6900 User Manual page 123

5.5. Indicators and Messages
Message
5HSODFH :DVWHð
WRQHU ERWWOH
0LVVLQJ :DVWHð
WRQHU ERWWOH
/RDGý SDSHU
(paper size)/(paper type)
*(paper size) and (paper type)
are displayed flashing
alternately.
/RDGý &DVVHWWHý ú
(paper size)/(paper type)
*(paper size) and (paper type)
are displayed flashing
alternately.
/RDGý 03ý WUD\
(paper size)/(paper type)
*(paper size) and (paper type)
are displayed flashing
alternately.
5-10
Replace the old waste toner bottle with the new one which is included
in the TK-20/TK-20H toner kit. The message will also be shown if the
waste toner bottle has become full. The waste toner bottle should be
replaced when the message display eventually showsý 7RQHUý ORZý
7.ðëíý&OHDQýSULQWHU. See Section 4.1.
Install the waste toner bottle. See Section 1.4. The printer does not
operate when this message is displayed.
The paper size does not match. The size of the paper in the cassette
is different to the size specified by the application software or by
PRESCRIBE 2e. Either put paper of the specified size into the cas-
sette. See Section 1.4.
If the CONTINUE key is pressed, printing will be resumed. However, if
more than one sheet is to be printed, the same message will again be
displayed from the second sheet onward. You can abandon printing
by pressing the CANCEL key.
There is data for printing that matches with a paper cassette setting
(paper size, paper type), but there is no paper in the cassette. Set
paper into the paper source as displayed on the control panel, and
press the CONTINUE key to restart printing. However, the paper
source number (ú) is only displayed when there is an optional paper
feeder installed.
Or, if you want to print from a different paper source press the FEED
key to displayý8VHýDOWHUQDWLYH" and you can change the
source for paper feeding. Further, you can change the paper source
by pressing the FEED key.
After selecting a paper source and pressing the MODE key,ý3DSHUý
KDQGOLQJý! appears. By pressing the
tings menu appears. After setting the correct paper type, press the
EXIT key and printing starts.
There is no paper cassette set (paper size, paper type) that matches
with the data for printing .
Because there is no cassette that matches the data, printing is done
from the MP tray. Set paper into the MP tray that matches the paper
size and type shown on the display and press the CONTINUE button to
restart printing.
Or, if you want to print from a different paper source press the FEED
key to displayý8VHýDOWHUQDWLYH" and you can change the
source for paper feeding. Further, you can change the paper source
by pressing the FEED key.
After selecting a paper source and pressing the MODE key,ý3DSHUý
KDQGOLQJý! appears. By pressing the
tings menu appears. After setting the correct paper type, press the
EXIT key and printing starts.
Corrective Action
key, the paper type set-
key, the paper type set-