Memory Card - Kyocera FS-6900 User Manual

1.6.

Memory Card

A memory card is a microchip card containing, for example, nonresident fonts and/or mac-
ros, forms, etc. The printer reads the contents of the card into its internal memory when
power is switched on. The presence of this data in the printer memory can be confirmed on
the status printout.
The maximum card capacity that can be used is 32 Megabytes. The type of the mem-
ory card to be used must be of either flash memory card (+5 V type) or SRAM-type
and conform to the PCMCIA 2.1 (JEIDA 4.2) standards. Please use a memory card
recommended by Kyocera.
The memory card slot is located at the bottom right of the printer.
To insert and use a memory card:
1.
Switch printer power off.
Do not insert or remove a memory card while power is on. If the memory card is
removed while the printer is on, damage could result in the printer's electronics or
the memory card.
2.
Insert the memory card in the slot. Insert it
face up, connector end first. Push it in all the
way.
3.
Switch printer power on. The printer reads the contents of the memory card during its
power-up sequence. The information (nonresident fonts, etc.) on the memory card is
now available for use.
If the memory card information is deleted from the printer's memory during the printing
process, it can be reread by using the mode selection function explained on the last page in
this manual.
To remove the memory card:
1.
Switch the power off.
2.
Remove the memory card from the slot.
Memory Card Slot
[PC CARD (MEMORY)]
1.6. Memory Card
Memory Card
1-27