Table of Contents
Advertisement
5.5 Indicators and Messages
Maintenance Messages
Table 5.2 Maintenance Messages
Message
7RS FRYHU
2SHQ
6LGH FRYHU
2SHQ
3DSHU IHHG XQLWý
2SHQ
$GG SDSHU
(paper source)
(paper size)/(paper type)
*(paper size) and (paper
type) are displayed flashing
alternately.
6HWý SDSHU
3UHVVý &217,18(
3DSHU MDP
:DUQLQJ
/RZ PHPRU\
2SWLRQý LQWHUIDFH
(UURU
7RQHU ORZ 7.ðëèý
&OHDQ SULQWHU
5HSODFH 7RQHUý
&OHDQ SULQWHU
&OHDQ SULQWHUý
3UHVV &217,18(
5HSODFH
:DVWHð
WRQHU ERWWOH
0LVVLQJ
:DVWHð
WRQHU ERWWOH
/RDGý &DVVHWWHý ú
(paper size)/(paper type)
*(paper size) and (paper
type) are displayed flashing
alternately.
5-8
Open the top cover, then close tightly.
Open the side cover, then close tightly.
Open the paper feed unit, then close tightly.
The paper has run out. Supply paper according to the paper source displayed (paper
cassette, MP tray, or optional paper feeder).
Add a sheet of paper to the MP tray, and press the CONTINUE key.
Open the top cover or the paper feed unit and correct the paper jam (or paper mis-feed-
ing in the cassette). See Section 5.6.
The printer's internal memory is running low due to the number of fonts and macros
downloaded. Print a status page to see how much user memory is left, and try deleting
unnecessary fonts and macros. See the PRESCRIBE 2e DELF and DELM commands
explanation in the programming manual (CD-ROM).
A failure has occurred with the option interface.
Check the optional interface installed on the printer.
Replace the toner container using a new toner kit. See Section 4.1.
Replace the toner container using a new toner kit. The printer does not operate when
this message is displayed. See section 4.1.
Please clean the inside of the printer. See Section 4.2.
This message will be displayed when replacing the toner container after the message
5HSODFHý7RQHUý&OHDQýSULQWHU has been displayed. After cleaning the
inside of the printer, press the CONTINUE key and the printer will be ready for printing.
Replace the old waste toner bottle with the new one which is included in the TK-25
toner kit. The message will also be shown if the waste toner bottle has become full. The
waste toner bottle should be replaced when the message display eventually showsý
7RQHUýORZý7.ðëèý&OHDQýSULQWHU. See Section 4.1.
Install the waste toner bottle. See Section 1.4. The printer does not operate when this
message is displayed.
There is data for printing that matches with a paper cassette setting (paper size, paper
type), but there is no paper in the cassette.
Set paper into the paper source as displayed on the control panel, and press the
CONTINUE key to restart printing. However, the paper source number (ú) is only dis-
played when there is an optional paper feeder installed.
Or, if you want to print from a different paper source press the FEED key to displayý 8VHý
DOWHUQDWLYH" and you can change the source for paper feeding. Further, you can
change the paper source by pressing the FEED key.
After selecting a paper source and pressing the MODE key,ý3DSHUýKDQGOLQJý!
appears. By pressing the
the correct paper type, press the EXIT key and printing starts.
Corrective Action
key, the paper type settings menu appears. After setting
Advertisement
Table of Contents
