Maintenance Messages - Kyocera Ecosys FS-3820N Operation Manual

Maintenance Messages

The following table lists maintenance messages that you can deal with by yourself. If Call service
person appears, turn off the printer, disconnect the power cord, and contact your Kyocera Mita dealer.
Message
Add paper (paper source)
Call service
F000
Call service
####
Call service
####:0123456
Cassette #
not loaded
Check waste
toner box
Clean printer
Press GO
Close duplexer
rear cover
Close
left cover
Close sorter
rear cover
Close
top cover
Close paper
transfer unit
Duplex disabled
Press GO
:Alarm buzzer sounds when an error occurs. Press the CANCEL key to stop the alarm buzzer.
Table 4-4
Corrective Action
The paper has run out. Supply paper according to the paper source displayed (paper
cassette, MP tray, or option paper feeder).
Messages indicating the printer status (Ready, Please wait, Processing
Waiting, and FormFeed Time Out
The ATTENTION indicator turns on and the READY indicator goes off. Indicates a
problem with the controller and the operator panel. Call a service person. The printer
does not operate when this message is displayed.
The ATTENTION indicator turns on. Indicates a controller error. Call a service person.
The printer does not operate when this message is displayed.
The ATTENTION indicator turns on. Indicates a mechanical error. Or an unsupported
option hardware has been installed. Be sure to install proper option hardware
compatible with the FS-3830N. Call a service person. 0123456 indicates the number
of printed pages.
The paper cassette may not be properly inserted into the printer. Reinsert the paper
cassette. The paper source number (#) is only displayed when there is an option paper
feeder installed.
The waste toner box is not installed. After installing the waste toner box, you should
be able to print. Replace the old waste toner box with the new one which is included
in the toner kit. The message will also be shown if the waste toner box has become full.
The waste toner box should be replaced when the message display eventually shows
Toner Container Replacement
Toner low. See
Please clean the inside of the printer. See
This message will be displayed when replacing the toner container after the message
Replace toner Clean printer is displayed. After cleaning the inside of the
printer, press the GO key and the printer will be ready for printing.
If Auto Continue is set to On, printing will be automatically resumed after a preset
period of time.
Open the option duplexer rear cover, then close tightly.
Open the left cover, then close tightly.
Open the sorter rear cover, then close tightly.
Open the top cover, then close tightly.
Open the paper transfer unit, then close tightly.
You attempted to print with a paper size and paper type that cannot be used for
duplex printing. Press the GO key to print onto one-side of the paper only.
†
) are displayed alternately.
Cleaning
4-7
Indicators and Messages
on page 3-2.
on page 3-9.
†
,