Smart Card Reader Assembly - HP EliteBook 2570p Maintenance And Service Manual

5. Remove the power button board (4) and cable by sliding it up and to the left at an angle.
Reverse this procedure to install the power button board.

Smart Card reader assembly

Description
Smart Card reader assembly (includes Smart Card reader cable and function LED board cable)
Before removing the Smart Card reader assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Bluetooth module (see
c. Speaker assembly (see
d. Optical drive (see
e. Hard drive (see
92 Chapter 4 Removal and replacement procedures
Battery on page 50), and then remove the following components:
Service cover on page
Bluetooth module on page
Speaker assembly on page
Optical drive on page
Hard drive on page 58)
52)
54)
56)
57)
Spare part number
685503-001