Display Assembly Subcomponents - HP EliteBook 2570p Maintenance And Service Manual

Display assembly subcomponents

NOTE: The display assembly is spared at the subcomponent level only. For more display assembly
spare part information, see the individual removal subsections.
To access the display assembly subcomponents, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Bluetooth module (see
c. Speaker assembly (see
d. Optical drive (see
e. Hard drive (see
f. Fan (see
g. WWAN module (see
h. Modem module (see
i. Keyboard (see
j. Base enclosure (see
k. System board (see
l. Top cover (see
1. If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a. Flex the inside edges of the bottom edge (1), the left and right sides (2), and the
top edge (3) of the display bezel until the bezel disengages from the display enclosure.
Battery on page
Service cover on page
Bluetooth module on page
Speaker assembly on page
Optical drive on page
Hard drive on page
Fan on page 60)
WWAN module on page
Modem module on page
Keyboard on page
Base enclosure on page
System board on page
Top cover on page
50), and then remove the following components:
52)
54)
56)
57)
58)
61)
68)
69)
74)
79)
87)
Component replacement procedures
95