Power Button Board - HP EliteBook 2570p Maintenance And Service Manual

Power button board

Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Bluetooth module (see
c. Speaker assembly (see
d. Optical drive (see
e. Hard drive (see
f. Fan (see
g. WWAN module (see
h. Modem module (see
i. Keyboard (see
j. Base enclosure (see
k. System board (see
l. Top cover (see
Remove the power button board:
1. Position the top cover with the top edge toward you.
2. Release the tape (1) the secures the power button board cable to the top cover.
3. Remove the Phillips PM2.0×3.6 screw (2) that secures the power button board to the top cover.
4. Lift the left side of the power button board (3) until it rests at an angle.
Battery on page
Service cover on page
Bluetooth module on page
Speaker assembly on page
Optical drive on page
Hard drive on page
Fan on page 60)
WWAN module on page
Modem module on page
Keyboard on page
Base enclosure on page
System board on page
Top cover on page
50), and then remove the following components:
52)
54)
56)
57)
58)
61)
68)
69)
74)
79)
87)
Component replacement procedures
Spare part number
685408-001
91