Smart Card Reader Assembly - HP EliteBook 2170p Maintenance And Service Manual

Smart Card reader assembly

Description
Smart Card reader assembly (includes cable)
Before removing the Smart Card reader assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Hard drive (see
c. WLAN module (see
d. WWAN module (see
e. Fan (see
f. Keyboard (see
g. Base enclosure (see
h. System board (see
Remove the Smart Card reader assembly:
1. Remove the two Phillips PM2.0×3.4 screws (1) that secure the Smart Card reader assembly to the
top cover.
2. Slide the Smart Card reader assembly (2) to the left to release it from the clips built into the
top cover.
Battery on page
Service cover on page
Hard drive on page
WLAN module on page
WWAN module on page
Fan on page 68)
Keyboard on page
Base enclosure on page
System board on page
56), and then remove the following components:
58)
59)
62)
64)
69)
76)
88)
Component replacement procedures
Spare part number
693312-001
93