Installing Additional Drives - HP 200 G1 Microtower Maintenance & Service Manual

Installing additional drives

When installing drives, follow these guidelines:
The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA
●
connector on the system board labeled SATA0.
Connect an optical drive to the white SATA connector on the system board labeled SATA1.
●
The power cables for the SATA drives connect directly to the power supply. The primary hard
●
drive connects to the power connector labeled P3. the primary optical drive connects to the power
connector labeled P5.
The system does not support Parallel ATA (PATA) optical drives or PATA hard drives.
●
CAUTION:
If you are inserting or removing a drive, shut down the operating system properly, turn off the
computer, and unplug the power cord. Do not remove a drive while the computer is on or in standby
mode.
Before handling a drive, ensure that you are discharged of static electricity. While handling a drive,
avoid touching the connector. For more information about preventing electrostatic damage, refer to
Electrostatic discharge information on page
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields
such as monitors or speakers.
If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and
label the package "Fragile: Handle With Care."
To prevent loss of work and damage to the computer or drive:
17.
Drives
37