System fan assembly
This section describes how to remove and install the system fan assembly.
Removing the system fan assembly
To remove the system fan assembly:
1.
Prepare the computer for servicing by following the
CAUTION:
data loss.
2.
Remove the access panel (see
3.
Remove the front bezel (see
4.
Remove the cables from the support arm on the airflow guide
5.
Remove the airflow guide by pulling it straight up and out of the chassis, as shown in the following
figure. (The processor heatsink is not shown.)
Figure 5-63
116
Chapter 5 Replacing components
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the access panel on page
Removing the front bezel on page
Removing the airflow guide
Predisassembly procedures on page
72).
74).
69.
ENWW