Camshaft Timing Pulley; Camshaft Timing Pulley - Disassembly/Assembly; Camshaft Timing Pulley - Reference Marks; Camshaft Timing - Kohler KDW 702 Workshop Manual

34
35
36
KD 702_1003_1404 Workshop Manual_cod. ED0053029340_1° ed_
37
Disassembly / Reassembly

Camshaft timing pulley

Camshaft timing pulley - Disassembly/Assembly

Unscrew screw 1 and remove the pulley. No extractor is needed.
 When refitting tighten the screw at a torque of 80 Nm.
Note: Assess any wear caused by the lip of the seal ring on the
pulley tang.

Camshaft timing pulley - Reference marks

1 Timing reference mark on cylinder head.
2 Camshaft pulley timing mark
3 Camshaft pulley timing
and 1404 engines.

Camshaft timing

Camshaft timing - Belt Reassembly

Important
Remove the distributor toothed belt from its protective
wrapping only when mounting it.
Make the connections for toothed belt fig. 33 and that of pulley
fig. 34 fit together.
Insert the belt (as in figure 35) taking account of the direction of
the arrows A impressed on it (direction of rotation).
Tighten the nut 1 by hand until the belt tightener rests on
surface of the crankcase.
Start by mounting the camshaft pulley belt, then mount
crankshaft's pulley.
Do not mount driven belts.
mark, for KDW, 702,
6
1003,
- 47 -