Table of Contents
Advertisement
6
Disassembly / Reassembly
97
99
101
- 62 -
98
100
102
KD 702_1003_1404 Workshop Manual_cod. ED0053029340_1° ed_ rev. 00
Oil pan, removal
Danger - Attention
- The used engine oil can cause skin-cancer if kept
frequently in contact for prolonged periods.
- If contact with oil cannot be avoided, wash carefully your
hands with water and soap as soon as possible.
- Do not disperse the oil in the ambient, as it has a high
pollution power.
Remove the fixing screws.
Insert a spacer 1 in the forward and rear main bearings.
Detach the silicon from the main bearing rubber bulb seals.
When re-mounting apply Silicone " Dow Corning 7091" as
shown in the picture.
Tighten the screws at a torque of 10 Nm.
Before starting the engine make sure that:
1) the oil drain plug is tightened correctly
2) the engine has been refilled with the prescribed quantity of oil
(see page 34).
PISTON
Remove the connecting rod big end cap.
Remove the piston-connecting rod assembly.
Note: The Ricardo type of combustion chamber is used for
KDW 702-1003-1404 engines.
Stop pin rings, dismounting and remounting
Extract the ring inserting a pointed tool in hollow A.
On remounting, insert rings with the points turned downwards
inside the corners ( a = 15°).
Advertisement
Table of Contents
