Windows 3.1 And Windows For Workgroups - Axis 570 User Manual

AXIS 570/670 User's Manual

Windows 3.1 and Windows for Workgroups

Windows 3.1
Windows for
Workgroups
Peer-to-Peer Printing
In order to print to a network printer, Windows 3.1 requires the
installation of network support, such as the LAN Server or LAN
Manager Workstation software. When installed, proceed as described
under Windows for Workgroups below.
Follow the instructions below to install your AXIS 570/670 for peer-
to-peer printing at a Windows for Workgroups workstation:
1. Double-click the AXIS Print Utility icon.
2. In the Port menu, click Add.
3. In the NPS Port list, select the AXIS 570/670 port. The ports
appear as <name>.LP1, <name>.LP2, and <name>.CM1, where
<name> is AX followed by the last six digits of the AXIS 570/670
serial number, e.g AX100086.
4. Accept or change the suggested Windows port name and type any
required comment in the Description field. Make a note of the
Windows port name as you will need this later, then click OK to
install the Windows port.
5. In the Port menu, click Connect... to bring up the Windows
Printers dialog.
6. Select a printer driver from the list of Installed Printers (or click
Add>> to install a new driver), then click Connect...
7. Select the Windows port name from step 4 above (this name can
be found at the bottom of the Ports list).
8. Click OK to close the Connect dialog, and Close to close Printers.
The setup is completed and you can now print through your
AXIS 570/670.
Section 7: Setting Up - Windows
141