Axis 570 User Manual page 105

Section 5: Setting Up - IBM Mainframe
104
Verifying the
Communication:
6. Specify the IP Address of the client(s) that you want to assign to
this LU. This is the IP address of the AXIS 570/670, i.e. the same
as the INT_ADDR parameter in the Print Server.
7. Click OK.
1. Activate the connection you created in step 2 of the above SNA
Server - AXIS 570/670 connection procedures. The status of the
connection should be "active".
2. Make sure the corresponding LU in the host is activated.
3. Activate the TN3270 connection to the AXIS 570/670. The LUA
should change status to SSCP.
4. Check that the printer is connected to the AXIS 570/670
5. Send a print job from the host.
The AXIS 570/670 is now ready for use.
You can check the status of the TN3270E connection by printing
Notes:
a test page from the Print Server. This is done by pressing the test
button once. Make sure the TN3270E status (St:) line for your
server connection is defined as either:
•
•
•
For additional information about configuring other TN3270E
servers, refer to the Technical Notes via the AXIS Web pages.
SSCP
LU-1
LU-3
AXIS 570/670 User's Manual