Table of Contents
Advertisement
1.1 Installing the Copier
1.1
Installing the Copier
1.1.1
Installation Site
To ensure utmost safety and prevent possible malfunctions of the copier,
install it in a location which meets the following requirements.
A place away from a curtain or the like that may catch fire and burn
easily.
An area where there is no possibility of being splashed with water or
other types of liquid.
An area free from direct sunlight.
A place out of the direct air stream of an air conditioner, heater, or
ventilator.
A well-ventilated place.
A dry place.
A dust-free location.
An area not subject to undue vibration.
A stable and level location.
A place where ammonia or other organic gas is not generated.
A place which does not put the operator in the direct stream of exhaust
from the copier.
A place which is not near any kind of heating device.
1.1.2
Power Source
The power source voltage requirements are as follows.
Use a power source with little voltage fluctuation.
Voltage Fluctuation:
Frequency Fluctuation:
EP1030/EP1030F
Within ±10%
Within ±0.3%
2
Rev. 1.x/22.05.02
Hide quick links:
Advertisement
Table of Contents
