Safety Notes
1
Safety Notes
1.1
Installing the Copier
Installation Site
To ensure utmost safety and prevent possible malfunctions of the copier,
install it in a location which meets the following requirements.
A place away from a curtain or the like that may catch fire and burn
easily.
An area where there is no possibility of being splashed with water or
other types of liquid.
An area free from direct sunlight.
A place out of the direct air stream of an air conditioner, heater, or
ventilator.
A well-ventilated place.
A dry place.
A dust-free location.
An area not subject to undue vibration.
A stable and level location.
Power Source
The power source voltage requirements are as follows.
Use a power source with little voltage fluctuation.
Voltage Fluctuation:
Frequency Fluctuation:
If any other electrical equipment is sourced from the same power
outlet, make sure that the capacity of the outlet is not exceeded.
The outlet should be located near the copier and easily accessible.
Never connect by means of a multiple socket any other appliances or
machines to the outlet being used for the copier.
If an extension cord is needed, use one with a capacity more than the
power consumption of the copier.
Make sure that no unusual, excessive force is being applied to the
power cord or extension cord.
EP1054
Within ±10%
50/60 Hz Within ±0.3%
1
1-1