4.2 Drum Dehumidifier
4.2
Drum Dehumidifier
Drum Dehumidifier Function
High humidity or rapid changes in the temperature of the room (such as
when a heater is used in a cold location) can cause condensation1 on the
photosensitive drum2 of the copier which causes the copies to be blotchy.
The Drum Dehumidifier removes this condensation.
1. Condensation: Moisture in the air collects as droplets on cold surfaces.
2. PC Drum: The part of the copier that works much like photographic film.
Turn the Main Switch off. While
1
pressing the 6 Exposure
Control Key, turn the Main
Switch on. The copier is now in
the Drum Dehumidifier mode
which will continue for
approximately three minutes.
2
Press the Clear/Stop Key to
stop the Drum Dehumidifier
mode.
NOTE
Copying can be performed while the Drum Dehumidifier mode is in
operation.
The Drum Dehumidifier mode cannot be started during the operation
of Toner Replenishing, starter charging, paper misfeeds or other types
of trouble.
EP1030/EP1030F
Before Dehumidifying
30
After Dehumidifying
Rev. 1.x/22.05.02