Table of Contents
Advertisement
2
1. Installing the Copier
Installation Site
To ensure utmost safety and prevent possible malfunctions of the copier, install it in a location which
meets the following requirements.
N
A place away from a curtain or the like that may catch fire and burn easily.
N
An area where there is no possibility of being splashed with water or other types of liquid.
N
An area free from direct sunlight.
N
A place out of the direct air stream of an air conditioner, heater, or ventilator.
N
A well-ventilated place.
N
A dry place.
N
A dust-free location.
N
An area not subject to undue vibration.
N
A stable and level location.
Power Source
The power source voltage requirements are as follows.
N
Use a power source with little voltage fluctuation.
Voltage Fluctuation
Frequency Fluctuation
N
If any other electrical equipment is sourced from the same power outlet, make sure that the
capacity of the outlet is not exceeded.
N
The outlet should be located near the copier and easily accessible.
N
Never connect any other appliances or machines by means of a multiple socket to the outlet being
used for the copier.
N
If an extension cord is needed, use one with a capacity more than the power consumption of the
copier.
N
Make sure that no unusual, excessive force is being applied to the power cord or extension cord.
Grounding
To prevent receiving electrical shocks in the case of electrical leakage, always ground the copier.
Connect the grounding wire to:
N
The ground terminal of the outlet.
N
A grounding contact which complies with the local electrical standards.
NOTE
Never connect the grounding wire to a gas pipe, the grounding wire for a telephone, or a water
pipe.
: Within ±10%
: Within ±0.3%
Advertisement
Table of Contents
