5.7 C-Display
5.7
C-Display
When a malfunction occurs in the copier, "C" and a number will flash
alternately on the Display Panel. Copying cannot be performed at this
time. Use the following procedure to reset the copier.
Resetting the Copier
1
Turn the Main Switch off and
then on again. This will reset the
copier.
If the "C" appears again, contact
your service representative.
Before Calling Your Service Representative
Before calling the service representative, note the code being displayed.
Example: C00
Once the service representative has been contacted, turn the Main Switch
off and unplug the power cord.
EP1030/EP1030F
Flashes alternately
60
Rev. 1.x/22.05.02