Disabling Store To Usb; Configuration Of Job Flow Sheets; Enabling The Ports And Setting Up Tcp/Ip - Xerox D95 System Administration Manual

The default user ID is admin. When a passcode is required, the default passcode is
1111.
2. Press the Machine Status button.
3. Select the Tools tab.
4. Select Connectivity and Network Setup.
5. Select Port Settings.
6. Select USB.
7. Select Change Settings.
8. Select Port Status.
9. Select Enabled and then select Save.
10. Log out as the administrator and select Reboot Now.
11. When the machine reboots, log in again as the administrator.
12. Select Enter.
13. Repeat steps 2-5. then select Print Mode, PJL, Auto Eject Time, or Adobe
Communication Protocol to change any of these settings.
14. When you finish changing any of these settings, select Change Settings, and then
select Save.
15. Log out as the administrator.

Disabling Store to USB

1. In CentreWare Internet Services, select Properties > Services > Store to USB >
General.
2. Uncheck the box next to Enabled.
3. Select Apply.
4. Select Reboot Machine.

Configuration of Job Flow Sheets

This section describes how to configure the machine to use the Job Flow Sheets service.

Enabling the ports and setting up TCP/IP

To use the Job Sheets service, enable the SOAP port, SNMP port, and Internet service
port, and set IP addresses. The procedure for setting the machine follows.
Note
The configuration can also be performed using CentreWare Internet Services. Refer to
Using CentreWare Internet Services.
1. Enter the System Administrator Mode.
2. Enable the SOAP port.
a) Select System Settings.
b) Select Connectivity & Network Setup.
Xerox ® D95/D110/D125/D136 Copier/Printer
System Administration Guide
Using the Scan Service
5-13