Receiving Buffer - Ethertalk; Receiving Buffer - Port 9100; Substitute Tray; Paper Type Mismatch - Xerox D95 System Administration Manual

System Settings
• Hard Disk: When selected, the machine will use spooling. The receiving buffer for
spooling uses the hard disk.

Receiving Buffer - EtherTalk

Set the EtherTalk receiving buffer. Set a value from 1024 to 2048 KB, in 32 KB increments.

Receiving Buffer - Port 9100

Set the Port9100 receiving buffer. Set a value from 64 to 1024 KB, in 32 KB increments.

Other Settings

Make settings relating to the paper used in the machine.
1. Select System Settings and then Print Service Settings.
2. Select Other Settings.
3. Select the item to be set or changed, and select Change Settings.
4. Select the item to be changed.
5. Select Save.

Substitute Tray

When there is no tray containing the paper size selected by the automatic tray selection,
select whether or not to print replaced with paper loaded in another paper tray. In the
event of using substitute tray, set the size.
• Display Message: Do not use substitute tray, but display a paper loading message.
• Use Larger Size: Replace with the next larger paper size than that selected, and print
at the same size.
• Use Closest Size: Replace with the closest paper size to that selected, and print. If
necessary, the printing is automatically reduced in size.
Note
If there is a client specification, the client specification takes precedence.
• Select Tray 5 (Bypass): Prints on the paper loaded in tray 5 (Bypass).

Paper Type Mismatch

Set the action to be taken when the paper type loaded in the paper tray does not match
that specified.
• Print: Carry on printing, even if the paper type is different.
• Display Confirmation Screen: Show a confirmation screen, and prompt for action.
• Display Paper Supply Screen: This selection shows the Paper Supply screen when a
paper type mismatch occurs.
10-54 Xerox ® D95/D110/D125/D136 Copier/Printer
System Administration Guide