Preparations; Enabling The Wsd Scan Port; Enabling Wsd At A Workstation; Printing A Configuration Report - Xerox D95 System Administration Manual

Preparations

One of the following operating systems must be installed on the destination computer
to use the Store to WSD feature:
• Microsoft Windows 7
• Microsoft Windows Vista Service Pack 2

Enabling the WSD Scan Port

To use the Store to WSD service, enable the WSD scan port.
1. Log on as the System Administrator.
The default user ID is admin. When a passcode is required, the default passcode is
1111.
2. Press the Machine Status button.
3. Select the Tools tab.
4. Select Connectivity and Network Setup.
5. Select Port Settings.
6. Select WSD, and then select Change Settings.
You may need to use the arrow buttons to find WSD on the list.
7. Select WSD Scan - Port Status, and then select Change Settings.
8. Select Enabled, and then select Save.
9. Select Close until the Tools screen displays.
10. Select Close.
A machine reboot may be required, depending on the settings. If prompted, reboot
the machine.

Enabling WSD at a workstation

1. Enter the IP address of the machine.
2. Select Properties > Connectivity .
3. Select Protocols.
4. Select WSD.
5. Select the Enabled checkboxes to enable the services.
6. Select Apply and then select Reboot Machine.
7. Select OK to confirm the reboot.

Printing a Configuration Report

To confirm that the WSD port is set up correctly, print a configuration report.
1. Log in as the System Administrator.
Xerox ® D95/D110/D125/D136 Copier/Printer
System Administration Guide
Using the Scan Service
5-17