Configuring The Snmp Port - Xerox WorkCentre 7300 Series Administrator's Manual

Note: Enter the address in the format "xxx.xxx.xxx.xxx". The "xxx" should be a numeric value in the
range from 0 to 255. However, 224 - 255.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.
f. Select Save.
g. Configure TCP/IP – Subnet Mask and TCP/IP – Gateway Address using the same process as
stated above.
Note: Enter the Gateway address in the format "xxx.xxx.xxx.xxx". The "xxx" should be a numeric value
in the range from 0 to 255. However, 224 - 255.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.
Note: Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 240, 248, 252, 254,
and 255. However, you cannot use 0 between non-zero values.
If you do not set the gateway address, enter "0.0.0.0".
5. Select Close until the Tools tab screen is displayed.
6. Wait several seconds for the Auto Clear service to log you out.
7. If you changed any settings, the Device will automatically reboot to register and enable your new
settings. After the machine is restarted, print out a Configuration Report to confirm that the ports are
enabled and TCP/IP is correctly configured.
For information on how to print a Configuration Report, refer to the Configuration Report topic in the
Network Connectivity section of this guide.

Configuring the SNMP Port

Configure the transport protocol for the SNMP port using CentreWare Internet Services.
1. Start a web browser on a network connected workstation.
2. Enter the machine's IP address in the address box of the browser and press Enter.
3. Click the Properties tab.
4. Click Port Status.
5. Select (place a checkmark in) the UDP check box next to SNMP.
6. Click Apply.
7. Enter the System Administrator user ID and password when prompted and click OK.
8. Click the Reboot button when it displays. If a Reboot button fails to display, click the Status tab and
click Reboot Machine from that screen.
96