IP Address Resolution
19. On the Protocol Settings menu, press the selection line labeled IPv4 (or other mode) Address
Resolution.
20. Press the Change Settings button.
21. On the settings screen, note which one of the buttons is highlighted as the current setting for the TCP/
IP Addressing method. The available settings are DHCP, BOOTP, RARP, DHCP/Autonet, and
STATIC. DHCP/Autonet is the factory default setting.
22. To change settings, press your selection of choice, then press the Save button.
23. To exit the screen, without making any changes, press the Cancel button.
24. Press Close and, if you made any changes, the system will reboot.
IPv4 IP Address
1. Used for static IP Addressing (with "STATIC" selected as your addressing method), on the Protocol
Settings menu, press the selection line labeled IPv4 Address. Note that the IP Address may be
viewed, but not changed, with dynamic addressing enabled.
2. Press the Change Settings button.
3. On the settings screen, use the numeric keypad to enter in the appropriate IP Address.
4. To save settings, press the Save button.
5. To exit the screen, without making any changes, press the Cancel button.
IPv4 Subnet Mask
1. Used for static IP Addressing (with "STATIC" selected as your addressing method), on the Protocol
Settings menu, press the selection line labeled IPv4 Subnet Mask. Note that the Subnet Mask may
be viewed, but not changed, with dynamic addressing enabled.
2. Press the Change Settings button.
3. On the settings screen, use the numeric keypad to enter in the appropriate Subnet Mask.
4. To save settings, press the Save button.
5. To exit the screen, without making any changes, press the Cancel button.
IPv4 Gateway Address
1. Used for static IP Addressing (with "STATIC" selected as your addressing method), on the Protocol
Settings menu, press the selection line labeled IPv4 Gateway Address. Note that the Gateway
address may be viewed, but not changed, with dynamic addressing enabled.
2. Press the Change Settings button.
3. On the settings screen, use the numeric keypad to enter in the appropriate Gateway.
4. To save settings, press the Save button.
5. To exit the screen, without making any changes, press the Cancel button.
19