2-3 Step 2: Attach the Magazine Unit
Fit the tabs on the underside of the magazine unit into the base plate.
Tighten the cap screws.
Correct tool-change is impossible if the tabs are not engaged properly. Perform positioning carefully.
Cushioning material
34
Chapter 2 Installation
Remove the screw.
Open the magazine cover and gen-
tly pull out the cushioning material.
Remove the rubber bushing.
Rubber bushing
Screw
Secure in place with two more cap
screws.
Cap screws
Gently close the magazine cover.
(M8 x 16 mm)
Base plate
Tab