Table of Contents
Advertisement
6-2 Manual Operation of the ATC
To go back to the original screen, use the hand wheel to select [Return to main], then press the [ENTER] key.
About the Selection Items
TOOL 1 through TOOL 4:
RETURN:
This returns the tool holder to the magazine.
MAGAZINE COVER:
LENGTH SCAN:
FORCED RELEASE:
tool holder with your hand to keep it from falling.
Automatic Measurement of Tool Length
This performs the same operation as going to VPanel's [Magazine] dialog box and clicking the [Measure All] button. For
detailed information about automatic measurement of tool length, refer to the page indicated below.
☞ P. 59, "4-2 Automatic Measurement of Tool Length"
74
Chapter 6 Handy Panel
This grasps the tool holder.
This opens or closes the magazine cover.
This executes automatic measurement of tool length.
This performs a forced release of the tool holder. Perform the operation while supporting the
WARNING: This procedure
makes the machine operate. Before
you perform this procedure, check
to make sure that operation of the
machine will not create any hazard
or danger.
Press the [ENTER] key.
Advertisement
Table of Contents
