2-3 Step 2: Attach the Magazine Unit
Plastic screws
(M4 x 15 mm)
Orient the hole
in this direction.
Secure the cable carrier in place.
Continue by proceeding with "2-4 Step 3: Attach the Spindle and Cylinder."
38
Chapter 2 Installation
Slide the T-slot nuts into the
grooves.
Secure in place with two more cap
screws.
Gently close the magazine cover.
Cap screws
(M8 x 16 mm)
No Rotary Axis Unit
Install the Z-origin sensor.
For Use in Combination with a Rotary
Axis Unit
Installation of the Z-origin sensor is
not required.
Cable carrier
Cap screws
(M4 x 8 mm)