Table of Contents
Advertisement
2-4 Step 3: Attach the Spindle and Cylinder
Stripper bolts
(d8 x L15 mm)
Pass the belt through the ATC spindle.
Attach the ATC spindle. Tighten the cap screws in the sequence shown in the figure.
For the belt and the cap screws, use the items you removed in step 2.
40
Chapter 2 Installation
Install the air cylinder.
Turn gently, and when
movement stops, tighten
further by approx. 30˚.
Inner and Outer Sides
of the Belt
The inner side is slick.
Engage the belt onto the pulley.
Advertisement
Table of Contents
