Cleaning Inside The Magazine Cover; Care And Maintenance Of The Tool Holders And Spindle Nose; Adjusting The Air Pressure - Roland ZAT-540 User Manual

Cleaning Inside the Magazine Cover

Open the magazine cover and clean away any buildup of cutting waste inside. For information on how to open the magazine
cover, refer to the following.
☞ P. 52, "Mounting Tool Holders in the Magazine"

Care and Maintenance of the Tool Holders and Spindle Nose

Adjusting the Air Pressure

Before starting operations, check to make sure the reading on the meter for the air regulator is within the specified range,
and adjust as required.
☞ P. 45, "2-6 Step 5: Supply Compressed Air"
Before use, clean away any cutting waste and
excess grease. Failure to do so may affect runout
precision or cause slippage.
Perform maintenance diligently to prevent rust.
Thoroughly wipe off any skin oils or the like with
Protect this
a cleaning rag. When the machine is to be taken
area from rust.
out of use for some time, apply machine oil to
prevent rust.
7-1 Daily Care
Chapter 7 Appendix
77