Table of Contents
Advertisement
2-7 Step 6: Adjust the Tool-change Location
Adjust the Tool-change Location
Procedure
46
Chapter 2 Basic Operation
Start the modeling machine.
Go to the main window in VPanel
and make sure the information for the
ATC is displayed.
Mount a tool holder in stocker No. 1.
For information on how to mount this, see the
following page.
☞ P. 52, "3-2 Mounting the Tool Holders"
In VPanel, go to the [Options] menu
and click [Adjust ATC Height].
WARNING: This procedure
makes the machine operate. Before
you perform this procedure, check
to make sure that operation of the
machine will not create any hazard
or danger.
Click [Start Detection].
Advertisement
Table of Contents
