Preparing The Compressed-Air Source - Roland ZAT-540 User Manual

Preparing the Compressed-air Source

WARNING
The pressure of the compressed air must be not more than 1 MPa.
Exceeding this may cause rupture or other serious accident.
WARNING
Ensure no contamination of the supplied compressed air by any water, oils,
chemicals, or foreign objects.
Components may deteriorate or rupture, or the contaminants may be scattered,
posing a hazard.
This unit requires compressed air. Provide a compressor or other source that meets the following conditions.
Air pressure: 0.7 to 1.0 MPa

Amount of air: 50 L/min

Contamination by moisture, oils, chemicals, or other foreign matter is not permitted. The air must be

dry.
Attach the piping from the unit as described below. Use a suitable air hose.
Hose outer diameter: 10 mm (polyurethane tube)

About the Compressor
Contamination of the compressed air by foreign matter is undesirable. Use an oil-free compressor.

Moist air may cause rust. Use a device equipped with a dryer.

Stable pressure is required. Select a source that has an adequate tank capacity.

Be sure to drain periodically.

10 mm
2-1 Before Installing
Chapter 2 Installation
29