Table of Contents
Advertisement
4-2 Automatic Measurement of Tool Length
To Make the Tool Descend Rapidly
When it takes a long time for the tool to make contact with the sensor, turn the hand wheel on the handy panel counterclock-
wise. Be careful not to make the tool collide with the sensor. A collision makes accurate detection impossible. If a collision
occurs, redo the operation from the beginning.
Operation Using the Handy Panel
You can also perform this operation using the handy panel.
☞ P. 71, "Chapter 6 - Handy Panel"
61
Chapter 4 Tool-length Offset
Advertisement
Table of Contents
