Step 2: Automatic Correction - Roland DWX-50 Setup & Maintenance Manual



Go on to "STEP2: Automatic correction."

STEP 2: Automatic correction

Using VPanel, you can perform automatic correction for the position of ATC Magazine and Rotary axis unit.
You use the detection pin (included item) for the correction.
Procedure

Open the front cover.
Detach the dust collection cover, the cap, workpiece when attached.

Clean the cutting dust attached to the Main Clump and ATC Magazine.
Use blush or other items when cleaning the cutting dust. Rotate the main-clamp to clean its entire surface.
For information on how to clean, refer to page 48, "Cleaning After Cutting Operation Ends"
Before Starting the Operation
Select one for which you want to perform
the run-in operation when connecting more
than one machine.
 P. 41, "Connecting Multiple Units"
Click [Settings].
Click [Maintenance] tab.
Click [Run-in].
The run-in operation starts.
Chapter 1 Installation and Setup
45