Transmitting; Memory Transmission - Toshiba ESTUDIO170F Operation Manual

- TRANSMITTING

Memory Transmission

A Memory Transmission first scans and stores the document into memory prior to
a transmission to a remote facsimile(s).
Memory Transmission is automatically initiated with any of the following dialing
methods.
• One Touch Dialing (See page 89)
• Abbreviated Dialing (See page 90)
• Alphabet Dialing (See page 91)
• Keypad Dialing (See page 92)
You may reserve a transmission even when other Memory Communications are un-
der way.
Once scanning a document is started, the facsimile will dial, connect and start
transmission to the remote location. In the event the Memory becomes full,
Memory Release will hold originals in the ADF until the pages already stored into
memory are successfully transmitted. As each page is successfully transmitted,
the Memory for subsequent pages will be released and the next page is scanned.
If a connection is not established during the scanning procedure, Memory Release
will be disabled (see NOTES).
To bypass Memory Transmission, see page 96 on Direct Document Transmission.
File Number and Residual Memory
• FILE NUMBERS
The facsimile assigns a File Number to each transmission or polling-recep-
tion job for internal control of reserved communications.
This File Number is very useful, should it become necessary to cancel a
memory operation. It is also useful when tracking communication activities
using the transmission and reception journals (see page 186).
File Number Display Example:
SCANNING DOC
File No.
FILE NBR =
• RESIDUAL MEMORY
The amount of memory remaining for memory transmission usage is called
Residual Memory and is displayed as a percentage value.
Residual Memory Display Example:
JAN-31 09:43 AM 70%
NOTES:
1. If there is not enough Residual Memory or the
Job queue it at full capacity, a Memory Full
status may occur. If this occurs during scan-
ning a document for transmission, the fac-
simile displays MEMORY OVERFLOW.
2. If this message is displayed, press
sion. The Memory Overflow message will be reset and the document will be
ejected.
3. Wait until memory becomes available (i.e., after some reserved jobs are
completed), and retry the job later or use a Direct Document Transmission
(see page 95).
4. A maximum of 100 transmissions can be reserved for Memory Transmis-
sions (including Polling Reception reservations and mailboxes). Any trans-
mission attempted thereafter will result in a direct transmission from the
ADF.
P001
123
Residual Memory
AUTO RECEIVE
JAN-31 09:43 AM 100%
MEMORY OVERFLOW
STOP
to cancel the Memory Transmis-
93