Sending Recovery Transmission - Toshiba ESTUDIO170F Operation Manual

Sending Recovery Transmission

This operation is used to re-
send a document after the doc-
ument initially failed to be sent.
If recovery transmission is set
to ON, the document is stored
in the e-STUDIO170F for re-
sending.
NOTES:
• When the Recovery Trans-
mission is set to OFF, an
error tone and "NOT AL-
LOWED NOW" LCD
prompt result when Recov-
ery Transmission is se-
lected.
If there is no document
stored for recovery trans-
mission, an error tone
sounds and "NO ENTRY"
LCD prompt will be dis-
played.
• To change the default set-
ting of this function, refer
to page 145. The status
selection in this operation
will take precedence over
the default setting.
172
Display the
1
RECOVERY
TRANSMIT Menu
Press:
MENU
+
+
+
+
MENU
Press or to
view the jobs stored for resend-
ing. The information is dis-
played on the LCD display.
RECOVERY TX
[ENTER]:START
FILE NBR = 005
12345
To cancel the document, go to
Step 4.
2
Select the Desired
Job
When the sending document to
be recovered was sent using
the One Touch key, Abbrevi-
ated Dial Number, Group Num-
ber, or Alphabet Dialing, press:
You can also change the num-
ber of the remote facsimile if
dialed from the Dial Keypad.
To re-transmit the document or
change the facsimile number,
press .
JOB NUMBER 005
1.START
2.CHANGE
To start the transmission,
press:
The transmission starts imme-
diately if the phone line is
available.
To change the number, press:
FAX NUMBER (MAX128)
[12345 ]
3
Change the
Facsimile Number
Enter the new facsimile num-
ber.
If the correct number is en-
tered, press:
The transmission starts imme-
diately if the phone line is
available.
4
Cancel the
Document
Press:
JOB CANCEL
DELETE JOB NUMBER005
1.YES
2.NO