Quick Start; Terminal Id; Transmitting; Receiving - Toshiba e-STUDIO170F Owner's Manual

- QUICK START

This section provides several
quick start programming steps
to prepare your new facsimile
1
for immediate use.
These procedures are a simple
version of the detailed proce-
dures listed in the manual.
Press:
Next to each procedure head-
ing is a convenient page num-
ber reference for the detailed
procedure. Should you have
any difficulty with these simple
procedures, refer to the pages
listed for more information.
Enter your user ID (company
It is highly recommended that
name) using the Dial Keypad,
you take the time to read
press:
through this manual to get the
most from your new TOSHIBA
facsimile.
If you communicate internation-
ally, select:
Otherwise, select:
3 4

Terminal ID

Setting the Terminal ID (Page 42)
MENU
FAX NUMBER
, ,
[
Enter your facsimile's tele-
NAME (40MAX)
phone number, press:
[ ]
COMPLETED
Displayed for 2 seconds
INT. CODE ?
INITIAL SETUP
1.YES
3.TERMINAL ID
2.NO
Press:

Transmitting

2
Sending a Facsimile
(Page 93)
Load your document face down
(20MAX)
into the Document Support.
]
JAN-31 09:43 AM 100%
AUTO RECEIVE
Dial the remote facsimile using
the Dial Keypad located on the
Operation Panel. Remember to
include any access numbers
such as 9 or press the
ter the access number if you
normally have to wait for a dial
tone.
STOP
After the remote facsimile
number has been entered into
the keypad, press the green
START key.
START

Receiving

3
Receiving a
Facsimile (Page 102)
Your TOSHIBA facsimile has
been preset from the factory to
receive facsimile messages.
No special setup is required to
receive facsimile messages.
REDIAL
af-
PAUSE